Table of Contents
Advertisement
Replace the access cover on the back of the range. To
replace the wire cover, insert the two tabs into the
openings located below the opening and tighten the
three screws.
[5] ANTI-TIP DEVICE INSTALLATION
4 WARNING
- Any person should not
mm
step or sit on oven door.
You should install the Anti-
Tip Bracket supplied with
the range.
ie
- The range could be tipped and
injury might result from spilled hot
liquid, food, or the range itself.
- If the range is pulled away from
the wall for cleaning, service, or
any other reason, ensure that the
Anti-Tip Device is properly
reengaged when the range is
pushed back against the wall.
Anti-tip
aa
Screw must
enter wood
orconcrete
= jf"
—— i
AB
8
Wall plate
1. Locate the bracket using the template
An Anti-tip bracket is packaged with template. The
instructions include necessary information to
complete the installation.
Read and follow range installation instruction sheet
(template).
2. Level the range
Level the range by adjusting the leveling legs with a
wrench.
Leg
a
leveler
Raise o™
range
Use a level to check your adjustments. Place the level
diagonally on the oven rack, and check each direction
for level.
level
First check direction @.
After check direction @.
If the level doesn't show
level on the rack, adjust the
leveling legs with a wrench.
[6] FINAL INSTALLATION
« Move range close enough to the opening to plug
into the receptacle.
* Slide range into position insuring that the left back
leg slides under the anti-tip bracket. Range should sit
flush against the back wall when
properly installed.
* Carefully attempt to tip range forward to insure that
the anti-tip bracket is engaged
properly.
If properly
installed, the anti-bracket will prevent the range from
being tipped. If the range can be tipped, reinstall the
range until the bracket is properly installed and the
range will not tip forward.
* Turn on electrical power. Check the range for proper
operation as described in owner's manual.
10
Advertisement
Table of Contents
