Table of Contents
Advertisement
Parallel Interface
PNP I/O type FZ4-605-10/FZ4-655-10/FZ4-H605-10/FZ4-H655-10/FZ4-705-10/FZ4-755-10/FZ4-H705-10
•
Internal Specifications
[Input] signals: RESET, DI0 to DI7, DSA0, DSA1
Input voltage
ON current *1
ON voltage *1
OFF current *2
OFF voltage *2
ON delay
OFF delay
Internal circuit
*1 ON current/ON voltage
This refers to the current or voltage values needed to shift from the OFF → ON state. The ON voltage value is the potential
difference between each of the input terminals and COM IN.
*2 OFF current/OFF voltage
This refers to the current or voltage values needed to shift from the ON → OFF state. The OFF voltage value is the potential
difference between each of the input terminals and COM IN.
[Output] signals:
Output voltage
Load current
ON residual voltage
OFF leakage current
Internal circuit
•
I/O Connector
No.
Signal name
I/O Connector wiring is the same as NPN I/O type.
9
FZ4-H755-10/FZ4-1105-10/FZ4-1155-10/FZ4-H1105-10/FZ4-H1155-10/FZD-505-10/FZD-555-10
12 to 24 V DC ±10 %
5 mA min.
8.8 V min.
0.5 mA max.
1.1V max.
5 ms max.
0.7 ms max.
Input terminal
COM IN
BUSY0, RUN/BUSY1, OR0 to 1, GATE0 to 1,
ERROR, DO0 to 15, READY0 to 1
12 to 24 V DC ±10 %
45 mA max.
2 V max.
0.2 mA max.
Wire color Mark (red)
Function
[Input] signals: STEP0/ENCTRIG_Z0, STEP1/ENCTRIG_Z1,
Input voltage
ON current *1
ON voltage *1
OFF current *2
OFF voltage *2
ON delay
OFF delay
Internal circuit
[Output] signals: When STGOUT0-3 are used,
Output voltage
Load current
ON residual voltage
OFF leakage current
Internal circuit
COM OUT
Load
Output terminal
No.
Signal name
Wire color Mark (blk)
ENCTRIG_A0 to 1, ENCTRIG_B0 to 1
12 to 24 V DC ±10 %
5 mA min.
8.8 V min.
0.5 mA max.
0.8 V max.
0.1 ms max.
0.1 ms max.
Input terminal
COM IN
connect the COM IN terminal.
12 to 24 V DC ±10 %
45 mA max.
2 V max.
0.2 mA max.
Function
COM OUT
Output terminal
Load
COM IN
Advertisement
Table of Contents
