Dc Power Jack Connector Cn101 - HP Engage 15t Maintenance And Service Manual

3) Lift the CN501 connector from the circuit board.
4) Place the new component on the circuit board. Be sure that it matches the circuit board footprint.
5) Solder the new component.

DC Power Jack connector CN101

Repair the DC POWER JACK connector:
1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2) Lift the CN101 connector from the circuit board.
3) Place the new component on the circuit board. Be sure that it matches the circuit board footprint.
4) Solder the new component.
18