Pentax IQZoom160 Operating Manual page 49

Correcting the date
Use the strap clamp's protrusion to depress the
SELECT and ADJUST buttons.
1. Depress the SELECT button O to select the
category of digits on the LCD panel you want
to change blink.
2. Depress the ADJUST button 0 to change dig¬
its of the specified category you chose with the
SELECT button ©. Digits increase by one each
time you depress the ADJUST button 0.
Holding down the button will advance digits
continuously.
3. After the data has been adjusted, depress the
SELECT button
0
.
The bar mark (—) appears
on the LCD panel, indicating that data imprint¬
ing choices are possible.
• The blinking allows precise fine-tuning of
the internal clock to the beginning of a specified
minute. To do so, depress the mode button O
until "Day-Hour-Minute" digits appear and
then depress the SELECT button
0
to make
the blink. Then depress the adjust button
0
in sync with a time signal.
* If you release the shutter while the blinking
data is being corrected, the data cannot be im¬
printed.
Operational precautions
• The data on the LCD panel is imprinted on
each frame you expose.
• "Year-Month-Day" and "Day-Hour-Minute"
cannot be imprinted at the same time.
• As you release the shutter, the bar(—) mark on
the display blinks for a few seconds, indicating
the data has been imprinted.
• Move the panorama lever to the right or left to
switch the imprint mode between panorama
and standard.
• The dating unit automatically switches the im¬
print mode between the standard and panorama
according to the format mode selected.
• If there is bright colored object in the comer of
the picture where the data is imprinted, the data
may be difficult to read. When composing your
photographs, try to avoid brightly-colored sub¬
jects in that comer.
45