2 Place the film cartridge in the film chamber by
fitting its flat side on the top of the rewind shaft
first and then slide the top end of the film car¬
tridge into the camera.
3 Pull the film leader out far enough from the
cartridge to reach the take-up spool. Align the
tip of the film with the film leader end mark
O.
4 After the back cover is closed, the film auto¬
matically advances to the first frame.
Notes:
• If there is dirt on the film detector ©, film can¬
not be wound properly.
• Ensure the film is taut as illustrated on the illus¬
tration, Take up any slack in the film by push¬
ing it back into the cartridge.
• If the end of the film leader is extremely bent,
straighten it or cut off the bent portion.
X Slack No!
O
Flat Yes!
13