Advertisement
Unpacking and Examining Your Oven
Remove:
1=aHpacking materiaB from inside the oven cav-
ity;
however,
DO
NOT
REMOVE
THE
WAVEGURDE COVER, which is bcated on the
right cavity wall= Read
_ty door latches
encbsures
and SAVE
/
D_
......
Hinges
sealing surfaces
cov_eg
damaged
door seaUs
and sealing surfaces, broken or bose door hinges
and Uatches and dents inside the cavity or on the
the Operation Manual
2. the feature sticker, if
there is one, from the
outside of the door.
Check the oven for any
damage, such as mis-
aligned or bent door,
door. ff there is any damage, do not operate the
oven and contact your dealer or SHARP
AUTHORIZED
SERVICER.
Cheesing
a Location for Your Oven
You wHU use the oven frequently so pUanits loca-
tion for ease of use. It's wise, if possible, to have
counter space on at least one side of the oven.
Allow at least 2 inches on the sides, top and at
the rear of the oven for air circulation. Do not place
or install the oven in any area where heat and
steam are generated;
for example,
next to or
above a conventional
gas or electric range or
above a conventional wall oven. Heat and steam
may damage the electronics or the mechanical
parts of the oven.
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a
grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in
accordance with the National Electrical Code and local codes and ordinances. In the event of an electri-
cal short circuit, grounding reduces risk of electric shock by providing an escape wire for the electric
current.
WARNING - improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more
Permanent
and Correct
!nsta!!ation
protected electrical supply. It is recommended
that a separate circuit serv-
ing only this appliance be provided,
s-_oog _=ug ......
into a wall receptacle that is properly installed and grounded. Should you
only have a 2-prong outlet, have a qualified electrician install a correct wall
I f_._
receptacle,
arounding
Pin
A 3-prong adapter may be purchased and used temporarily if local codes
3-Prong
Receptac;e /
allow. Follow package directions.
A short power-supply cord is provided to reduce risk of becoming entangled
in or tripping over a longer cord.
Extension C0rd
around
Receptac',e Box
Temporary
Use
around
Grounding
Receptac',e
Box
If it is necessary to use an extension cord, use only a 3-wire extension cord
Adap,er
that has a 3-blade grounding plug and a 3-slot receptacle that wiil accept
\_ ,_
-,Hr------_
the phJg on the microwave oven, The marked rating of the extension cord
should beAC 115-120 volt, 15 amp. or
more.
_ri_]
!
Be careful not to drape the cord over the countertop or table where it can be
pulled on by children or tripped over accidentally.
_o b
Notes: 1. If you have any questions about the grounding or electrical in-
structions, consult a qualified electrician or service person.
2. Neither Sharp nor the dealer can accept any liability for damage
to the oven or personal injury resulting from failure to observe the
correct electrical connection procedures.
Radio 0r TV interference
Should there be any interference caused by the microwave oven to your radio or TV, check that the
microwave oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as
feasible or check position and signal of receiving antenna.
3
Advertisement
