Advertisement
In order for the water softening system to give fault-free service, the appliance
performs a regeneration cycle of the system at regular intervals.
The regeneration process consists of several stages. It starts at the end of the last
rinse cycle, after the amount of water indicated in the mains water hardness setting
has been reached during the wash cycle, and finishes at the beginning of the
following wash cycle.
The regeneration process increases the cycle time and consumption of water and
electricity.
Below is an overview of consumption of regeneration the softening system using the
Eco program with a water hardness setting of H2.
Water
consumption
according to
Regeneration
model
frequency
[refer to the
programs
(number of
table]
(litres)
7
Be careful not to confuse the salt and detergent packages; adding
detergent to the salt container will damage the water softening system.
Istruzioni per l'utente
Water
consumption
during
regeneration
(litres)
At
the
end
cycles)
of
the
last
rinse
8
0.2
Each time the salt container is refilled, make sure that the cap is
securely closed. The mixture of water and detergent must never
penetrate the salt container, as this would compromise the operation
of the regeneration system. In this case warranty cover will be
forfeited.
Only
use
regeneration
dishwashers. Do not use table salt, since it contains insoluble
substances that could damage the water softener system.
After having added salt, run a wash cycle to remove any excess salt.
In this way, the excess saline solution will be immediately removed
by the water; the prolonged presence of salt water inside the tank may
lead to corrosion.
Energy
consumption
during
regeneration
(Wh)
At the
At
beginning
the
of the
end
following
of
wash
the
cycle
last
rinse
4
(10x0.4
0.3
litres)
salt
Duration of the
regeneration
process
(min)
At the
At
beginning
the
of the
end
following
of
wash
the
cycle
last
rinse
1.2
6
specifically
for
At the
beginning
of the
following
wash
cycle
4
domestic
29
Advertisement
Troubleshooting
