Smeg DF352CS Manual page 22

In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph "
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program will
start about 60 seconds later.
Option
1 SPECIAL
2 DRY ASSIST
3 EXTRA DRY
½ LOAD
4
FLEXY ZONE
5 DELAY
6 SELF CLEAN
SPECIAL (if present)
Allows you to enable additional programs when selected together with any
wash cycle. After having selected the required wash cycle, press the
button (the light turns on). It turns off automatically when the cycle has
finished.
½ LOAD FLEXI ZONE (if present)
Ideal if just a few dishes need to be washed, allowing energy savings. The
dishes should be placed in both baskets and less detergent should be
placed in the detergent dispenser compared to the amount used for a full
load.
Istruzioni per l'utente
S
TARTING THE PROGRAM
OPTION SELECTION
Options are selected by pressing the relative button by the
symbol of the option required; the light comes on to confirm
that the option has been activated.
Options are selected by pressing the relative button by the
symbol of the option required; the light comes on to confirm
that the option has been activated.
All the options are deactivated at the end of the wash
cycle.
Allows the dishes to be dried perfectly even at low
rinse temperatures, with significant energy savings. It
starts automatically if the selected program is
compatible with it. If it is not required, press the
Modifies some of the parameters to ensure improved
It does not affect the Eco program (regulatory).
Ideal if just a few dishes need to be washed, allowing
energy savings and a shorter wash cycle.
Allows the wash cycles 1 or 3 to be delayed by up to
9, 12 or 24 hours depending on the models.
Dishwasher cleaning cycle. Must be started with the
". The program will resume from the
Description
Creates additional programs.
button to disable it.
drying.
machine empty, without dishes.
22