Real Time Clock - Toshiba Satellite M40X-119 User Manual

Troubleshooting
Standby/Hibernation
Problem
The system will not
enter Standby/
Hibernation

Real Time Clock

Problem
The following
message is Displayed
on the LCD:
RTC battery is low or
CMOS checksum is
inconsistent. Press
[F2] key to set Date/
Time.
Memory expansion
Refer also to Chapter 8, Optional Devices, for information on installing
memory modules.
Problem
The computer hangs up
and issues beep
sounds. (A long leep,
three short beeps, three
short beeps, and then a
long beep.)
9-14
Procedure
Is Windows ® Media Player open? The system
might not enter Standby/Hibernation,
®
if Windows Media Player is either playing a
selection or finished playing a selection.
®
Close Windows Media Player before you select
Standby/Hibernation.
If problems persist, contact your dealer.
Procedure
The battery for RTC is wearing. Set the date and
time in BIOS setup with the following steps:
1. Press [F1] key. BIOS setup will boot up.
2. Press [F2] to set the date in [System Date].
3. Press [F2] to set the time in [System Time].
Procedure
Make sure the memory module installed in the
expansion slot is compatible with the computer.
If an incompatible module has been installed,
follow the steps below.
1. Turn off the power.
2. Disconnect the AC adapter and all periph-eral
devices.
3. Remove the battery pack.
4. Remove the memory module.
5. Replace the battery pack and/or connect the
AC adapter.
6. Turn on the power.
If problems persist, contact your dealer.
User's Manual