Pre-Separator And Dust Collector - Husqvarna Blastrac BMG 2200RC Operator's Manual

Table of Contents

Advertisement

10. Disconnect the electrical cable of the Dwyer Magnesense
(11).
11. Loosen pin to disconnect the pre-separator (8).
12. Clean the system wth the air pistol (9).
13. Observe the air pressure gauge (10).
14. Use a crane or other lifting device to lift the pre-separator
off of the hinges and put it on its side to prevent damages.
Do not set the pre-separator down on the Longopack.
15. Place the water tanks on the hinges.
16. Connect the hose from the water tank to the water-filter
(12), safe the hose with the hose clamp.
17. Go to the SETTINGS MENU (14, refer to fig. on page 20)
and select "Water" (15, refer to fig. on page 20) in the "Dust
System" selection area.
18. When "Water" is selected, the dust collector cannot be
operated and vice versa.
19. Open all valves and use the "DUSTCOLLECTOR" button (10,
refer to fig. on page 19) to activate the water spray nozzles
in the MAIN MENU.
20. Fill the water tanks with a clean water. Dirty water can clog
the system.
21. Remove the screws to open the caps, on top of the water tanks, to fill them. Do not forget to close the
caps after you fill them. Splash of the water can damage the electrical system.
22. Make sure that the water supply is stopped before you connect or disconnect it to the machine.
Be careful, the work floor can get slippery when grinding wet.
Keep all electrical cables and connections away from water.
23. Clean the brush-sealing directly after wet grinding. It is not easy to remove the dry and hard dust-
water mixture from the brush-sealing.
5.10

Pre-separator and dust collector

The dust from the grinding heads is transported to 1 point, after which
the dust is transported to the pre-separator. The pre-separator will
separate up to 95% of the dust into the Longopack disposal system.
The lighter dust is filtered from the air inside the dust collector by
4 industrial size M-class filters. The filters are automatically cleaned
every 15 seconds by the pulse cleaning system. The dust from the
dust collector falls into a Longopack bag, to easy remove the dust.
After the filtration by the 4 M-class filters, the air goes through the
oversized HEPA-filter (H14) which has a filtration efficiency of
99,995% and clean air will exit.
28
6
5
11
7
8
9
10
12
21.07.2023

Advertisement

Table of Contents
loading

This manual is also suitable for:

970 61 65-02

Table of Contents