Instrument and control functions
higher the spring preload; the
shorter distance A is, the lower the
spring preload.
Use the special wrench in the
tool kit to make the adjust-
ment.
1
5
(a)
1. Spring preload adjusting nut
2. Locknut
1
1. Distance A
Spring preload:
Minimum (soft):
Distance A = 0.0 mm (0.00 in)
Standard:
Distance A = 4.0 mm (0.16 in)
Maximum (hard):
Distance A = 9.0 mm (0.35 in)
2
3. Tighten the locknut to the speci-
fied torque. NOTICE: Always
(b)
tighten the locknut against the
adjusting nut, and then tighten
the locknut to the specified
torque.
[ECA10122]
Tightening torque:
Locknut:
25 N·m (2.5 kgf·m, 18 lb·ft)
NOTICE
To avoid damaging the mechanism,
do not attempt to turn beyond the
maximum or minimum settings.
EXUP system
This model is equipped with Yamaha's
EXUP (EXhaust Ultimate Power valve)
system. This system boosts engine
power by means of a valve that con-
trols exhaust flow within the exhaust
chamber.
NOTICE
The EXUP system has been set and
extensively tested at the Yamaha
factory. Changing these settings
without sufficient technical knowl-
edge may result in poor perfor-
mance of or damage to the engine.
ECA10102
5-46
EAU67050
ECA15611