BMW 4 Coupe Series Manual page 243

and vehicle surroundings closely and actively
intervene where appropriate.
Overview
Depending on the vehicle
equipment: button in the vehicle
Park assistance button
Sensors
The system is controlled by the following sen‐
sors:
▷ Rearview camera.
Additional information:
Sensors of the vehicle, refer to page 37.
Turning on/off
Turning on automatically
The system is switched on automatically if selec‐
tor lever position R is engaged when the engine
is running.
Automatic deactivation during
forward travel
The system switches off when a certain driving
distance or speed is exceeded.
Switch the system back on, if needed.
Driver assistance systems
Online Edition for Part no. 01405A392C9 - VI/21
Depending on the vehicle
equipment: switching on/off
manually
Press the park assistance button.
▷ On: the LED lights up.
▷ Off: the LED goes out.
The parking assistance functions are shown on
the Control Display.
Switching the view via iDrive
If the rearview camera view is not displayed,
change the view via iDrive:
1. If necessary, tilt the Controller to the side.
2. "Rear view camera"
The rearview camera image is displayed.
Functional requirements
▷ The trunk lid is fully closed.
▷ Keep the recording range of the camera
open. Protruding cargo, roof rack systems or
trailers can limit the detection range of the
camera.
Display on the Control Display
Toolbars
The assistance functions can be activated man‐
ually via the toolbars on the sides of the Control
Display.
1. Move the Controller to the right, if needed.
2. With corresponding equipment:
"Camera image"
3. ▷
"Parking aid lines".
Pathway lines and turning circle lines are
displayed.
▷ "Obstacle mark.".
Depending on the vehicle equipment, the
obstacles detected by PDC Park Distance
Control are displayed by markings.
CONTROLS
243