Service
3. Reposition the pinion/gear assembly (10, 15)
in the lower housing, thread the large gear (9)
onto the agitator shaft, and tighten the large gear
hand tight.
4. Make sure the small thrust balls (4) are in place.
5. Carefully lowering it straight down, reposition the
upper housing (1) on the lower housing (2).
6. Replace the two short bolts (11) and the two long
bolts (19) that hold the upper housing (8) and the
lower housing (13) together, and torque the bolts
to 75 in-lb (8.5 N-m).
7. Remove the blocks that you have supporting the
agitator housing, and reposition the agitator on
the drum cover.
12
8. Thread the three hex head screws up through
the drum cover and into the agitator, and torque
them to 75 in-lb (8.4 N-m).
9. If your agitator has a siphon kit, re-install it by
doing the reverse of steps 2 through 4 in
the Agitator Shaft with Siphon Kit, page
Additional Agitator Service
If the unit requires more than installation of a bearing
replacement kit or gear replacement, it may be
advisable to send the unit to a Graco distributor for
repair or replacement.
Cleaning
11.
3A4548A