Siemens MAMMOMAT 3000 Opdima Service Instructions Manual page 13

•
Push the CPU board slightly to the back and remove the board and place it on the
grounded tabletop pad.
Fig. 4
•
Remove the NVRAM (refer to chapter "Replacing the NVRAM").
•
Remove DSIMMs (refer to chapter "Replacing the Memory Module").
•
Remove the Camera Interface D100 from the defective CPU board (refer to chapter
"Replacing the Camera Interface D100).
•
Remove the Frame Buffer (refer to the chapter "Replacing the Frame Buffer").
•
On the new CPU board, install the previously removed NVRAM and the memory
modules.
Siemens-Elema AB
Solna, Sweden
Removing the Ultra 1
Register 5 SPB7-230.061.02
Rev. 02
Page 3 of 20
05.99 SPS-UD





'
3
2
MAMMOMAT 3000 Opdima
Service
2