Eject Button - Siemens MAMMOMAT 3000 Opdima Service Instructions Manual

•
Open the SBUS card retainers.
•
Insert the new PCMCIA SBUS board carefully in the in the original location.
•
Close the top cover of the box (refer to chapter 1).
•
Connect the external connector to the PCMCIA SBUS board.
•
Release the interface by pushing the eject button (refer to Fig. 15).

Eject button

Fig. 15 PCMCIA Interface
•
Switch on power to the system.
•
Ensure that the system is operating properly.
Siemens-Elema AB
Solna, Sweden
Register 5 SPB7-230.061.02
Rev. 02
•
Insert the new PCMCIA interface
carefully in the interface slot (refer to
Fig. 15).
•
Connect the front connector of the
PCMCIA interface.
Page 17 of 20
05.99 SPS-UD
MAMMOMAT 3000 Opdima
Service
2
2
2