Table of Contents
Advertisement
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (48) so that the treadmill is more stable;
do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Cut the shipping tie securing the Upright Wire
(77) to the Base (85). Locate a tie in the indi-
cated hole in the Base, and use the tie to pull the
Upright Wire out of the hole.
Attach a Base Pad (81) to the Base (85) in the
location shown with an M4.2 x 25mm Tek Screw
(2) and a Base Pad Spacer (104). Then, attach a
Base Pad (81) in the location shown with only an
M4.2 x 25mm Tek Screw (2).
2. Remove the M10 Nut (33), the M10 x 50mm Bolt
(4), and the shipping bracket (C) from the Base
(85). Attach a Wheel (86) with the Bolt and the
Nut that you just removed. Do not overtighten
the Nut; the Wheel must turn freely. Discard
the shipping bracket.
Press a Base Endcap (82) into the Base (85).
All manuals and user guides at all-guides.com
7
1
77
48
104
81
2
2
4
85
86
C
33
B
A
Hole
81
2
85
82
Advertisement
Table of Contents
