Table of Contents
Advertisement
5. Select a display mode and monitor your
progress with the display.
When the manual mode is selected, the console
offers two display modes. Press the Display button
repeatedly to select the desired display mode.
As you walk or run on the treadmill, the display can
show the following workout information:
• A 1/4-mile (400 meter) track.
• The approximate number of calories you have
burned.
• The elapsed time.
• The distance that you have walked or run.
• The incline level of the treadmill.
• The speed of the walking belt.
Regardless of which display mode you select, the
speed or incline setting will appear in the display
for a few seconds each time you change the set-
ting. In addition, your heart rate will appear in the
display each time you use the handgrip pulse sen-
sor or the optional chest pulse sensor.
To reset the console, press the Stop button, re-
move the key, and then reinsert the key.
6. Measure your heart rate if desired.
Note: If you use the handgrip pulse sensor and
the optional chest pulse sensor at the same
time, the display will not show your heart rate
accurately. For information about the optional
chest pulse sensor, see page 19.
All manuals and user guides at all-guides.com
16
Before using the
handgrip pulse
sensor, remove
the sheets of
clear plastic from
the metal con-
tacts on the pulse
bar. In addition,
make sure that
your hands are clean.
To measure your heart rate, stand on the foot
rails and hold the pulse bar with your palms on the
metal contacts. Avoid moving your hands. When
your pulse is detected, a heart symbol will flash in
the display each time your heart beats, one or two
dashes will appear, and then your heart rate will be
shown. For the most accurate heart rate read-
ing, continue to hold the contacts for about 15
seconds.
7. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest set-
ting or you may damage the treadmill when you
fold it to the storage position. Next, remove the
key from the console and put it in a secure place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the "off" position and
unplug the power cord. IMPORTANT: If you do
not do this, the treadmillʼs electrical compo-
nents may wear prematurely.
Contacts
Advertisement
Table of Contents
