AEG LFR9514L6U User Manual page 38

1. The appliance detects the load in the first
30 seconds: the indicator
bars under the
and forth and the drum rotates shortly.
2. When the drum stops rotating, the display
shows the new programme duration, that
could increase or decrease, adjusted
accordingly the load detected, the
number of bars indicates the load in
quarter (from 1 to 4, 4 bars in case of
overload), the maximum declared load
indicator comes on again. After further 30
seconds, the water filling starts.
In case of in case of drum overload,
the maximum declared load indicator
comes on again with the
indicator blinking. In this case, during
these 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
Once removed the exceeding
garments, touch the Start/Pause
button to start the programme again.
The ProSense phase can be
repeated up to three times (see point
1).
Important! If the laundry amount will not be
reduced, the washing programme starts
anyway, despite the overload. In this case, it
will be not possible to guarantee the best
washing results.
About 20 minutes after the programme
start, the programme duration could be
adjusted again depending on the
capacity of water absorption of the
fabrics.
The ProSense detection is carried out
with complete washing programmes only
(no skipping phase selected).
38 ENGLISH
flashes, the
icon move back
The ProSense is not available with some
programmes, such as Wool, programmes
with short cycles and without washing
phase.
13.8 Programme phase indicators
When the programme starts the indicator of
the running phase flashes and the other
phase indicators are steady on.
E.g. the washing or pre wash phase is
running: .
When the phase ends the relevant indicator
stops flashing and is steady on. The next
phase indicator starts flashing.
E.g. the rinse phase is running:
If you select the Plus Steam the steam phase
indicators come on.
The steam phase is running:
The anti-crease phase is running:
13.9 Interrupting a programme and
changing the options
When the programme is running, you can
change only some options:
1. Touch the Start/Pause
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the Start/Pause
The washing programme continues.
13.10 Cancelling a running
programme
1. Press the On/Off
programme and to deactivate the
appliance.
2. Press the On/Off
activate the appliance.
.
.
.
button.
button again.
button to cancel the
button again to