AEG LFR9514L6U User Manual page 15

It is possible to connect the drain hose in different ways:
min.600 mm
max.1000 mm
• Connect the drain hose to the spigot and
tighten it with a clamp.
• Position the hose directly to a built-in drain
pipe in the room wall and tighten it with a
clamp.
• Without the plastic hose guide, to a sink
spigot - put the drain hose in the spigot
and tighten it with a clamp.
• To a stand pipe with vent hole - insert the
drain hose directly into a drain pipe or
stand pipe.
• The drain hose can be bent into U shape
and put around the plastic guide. On the
edge of a sink - fasten the guide to the
water tap or to the wall.
Make sure that the drain hose makes a
loop to prevent particles going into the
appliance from the sink.
Make sure that the plastic guide cannot
move when the appliance drains and the
drain hose end is not immersed in the
water. There may be a return of dirty
water into the appliance. Buy accessories
from authorised supplier.
The end of the drain hose must always
be ventilated , i.e. the inner diameter of
the drain pipe (min. 38 mm - min. 1.5")
must be larger than the external diameter
of the drain hose.
5.8 Electrical connection
At the end of installation you can connect the
mains plug to the mains socket.
The rating plate and the 'Technical Data'
chapter indicate the necessary electrical
ratings. Make sure that they are compatible
with the mains power supply.
Check that your domestic electrical
installation can take the maximum load
required, also taking into account any other
appliances in use.
ENGLISH 15