Traxxas RUSTER 4x4 BRUSHLESS Owner's Manual
  1. Manuals
  2. Brands
  3. Traxxas Manuals
  4. Motorized Toy Car
  5. RUSTER 4x4 BRUSHLESS
  6. Owner's manual
Traxxas RUSTER 4x4 BRUSHLESS Owner's Manual

Traxxas RUSTER 4x4 BRUSHLESS Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
MODEL 67164-4
1
owner
s manual
'

Advertisement

Table of Contents
loading

Related Manuals for Traxxas RUSTER 4x4 BRUSHLESS

Summary of Contents for Traxxas RUSTER 4x4 BRUSHLESS

  • Page 1 MODEL 67164-4 owner s manual ’...
  • Page 2 Traxxas.com/register. DRIVING YOUR MODEL Thank you again for choosing Traxxas. We work hard every day T r a x x a s . c o m / r e g i s t e r to ensure you receive the highest level of customer satisfaction ADJUSTING possible.

  • Page 3: Before You Proceed

    Traxxas service needs. Maintenance and replacement identified by the icons below. Be sure to read them! To-Win, Rustler 4X4, BL-2s, and parts may be purchased directly from Traxxas by phone or online ProGraphix are trademarks or An important warning about personal safety or avoiding at Traxxas.com.

  • Page 4: Safety Precautions

    SAFETY PRECAUTIONS All of us at Traxxas want you to safely enjoy your new model. Operate • Insulate the Wires: Always insulate exposed wiring with heat shrink your model sensibly and with care, and it will be exciting, safe, and tubing to prevent short circuits.
  • Page 5 • ONLY use a Traxxas iD charger to charge Traxxas iD batteries. identifying the battery type and specifications. ALWAYS use a ONLY use a Lithium Polymer (LiPo) balance charger with a Traxxas iD charger to charge Traxxas iD batteries.
  • Page 6 SAFETY PRECAUTIONS (continued from previous page) • While charging or discharging, ALWAYS place the battery (all • DO NOT disassemble, crush, short circuit, or expose the batteries to types of batteries) in a fire retardant/fire proof container and on flame or other source of ignition. Toxic materials could be released. a non-flammable surface such as concrete.

  • Page 7: Tools, Supplies, And Required Equipment

    R/C toolbox: • Safety glasses EZ-Peak Dual ™ (Part #2972) • Traxxas Ultra Premium Tire Glue, part #6468 (CA glue) Foam battery spacer • Hobby knife • Side cutters and/or needle nose pliers 6 or 7-cell NiMH battery pack, or...
  • Page 8 ANATOMY OF THE RUSTLER 4X4 BRUSHLESS Shock Battery Hold-Down Battery Compartment Steering Block Caster Block Rear Camber Link Drive Shaft Traxxas High-Current Front Camber Link Connector Rear Shock Tower Receiver Box Front Bumper Spur Gear Front Shock Tower Rear Bumper...

  • Page 9: Quick Start: Getting Up To Speed

    QUICK START: GETTING UP TO SPEED The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom corners of Quick Start pages. The Quick Start Guide is not intended to replace the full operating instructions 1.
  • Page 10 TRAXXAS TQ 2.4GHz RADIO SYSTEM INTRODUCTION power more efficiently than mechanical speed controls so that Your model includes the TQ 2.4GHz transmitter. When powered the batteries run longer. An electronic speed control also has Applying the Decals on, the TQ 2.4GHz will automatically locate and lock onto an...
  • Page 11 TRAXXAS TQ 2.4GHz RADIO SYSTEM Resistance - In an electrical sense, resistance is a measure of how 2-channel radio system - The TQ radio system, consisting of an object resists or obstructs the flow of current through it. the receiver, the transmitter, and the servos. The system uses To prevent loss of radio range, When flow is constricted, energy is converted to heat and is lost.
  • Page 12 TRAXXAS TQ 2.4GHz RADIO SYSTEM Your model is equipped with the Traxxas TQ 2.4GHz transmitter. MODEL WIRING DIAGRAM BL-2s Wiring Diagram The transmitter has two channels: Channel one operates the Motor steering, and channel two operates the throttle. The receiver...
  • Page 13 Refer to the select. Traxxas recommends you choose a genuine Traxxas EZ-Peak iD Troubleshooting section on page 17 for more information on charger for safer charging and maximum battery life and performance.
  • Page 14 Secure, long-lasting, and easy to separately) to automatically recognize connected battery grip, the Traxxas connector is engineered to extract all the power your packs and optimize the battery has to give. charge settings for the battery.
  • Page 15 TRAXXAS TQ 2.4GHz RADIO SYSTEM RADIO SYSTEM CONTROLS • In order for the transmitter and receiver to bind to one another, the receiver in the model must be turned on within 20 seconds Remember, always turn the of turning on the transmitter. The transmitter LED will flash fast transmitter on first and off red, indicating a failure to link.
  • Page 16 TRAXXAS TQ 2.4GHz RADIO SYSTEM Throttle reversing procedure: 6. When looking down at the Note: Throttle reversing is often times unnecessary on electric model, the front wheels Using Reverse: While driving, models, as issues with the throttle can usually be solved by...
  • Page 17 TRAXXAS TQ 2.4GHz RADIO SYSTEM Higher Speeds Require Greater Distance TQ 2.4GHz Binding Instructions The faster you drive your model, the more quickly it will near the For proper operation, the transmitter and receiver must be Failsafe limit of radio range. At top speeds, models can cover anywhere electronically ‘bound.’...

  • Page 18: Adjusting The Electronic Speed Control

    1. Turn the transmitter off. transmission on high-traction surfaces. 2. Hold both MENU and SET. 7. To turn the BL-2s off, press the EZ-Set button until the LED turns 18 • TRAXXAS 3. Turn the transmitter on. off (.5 seconds).
  • Page 19 ADJUSTING THE ELECTRONIC SPEED CONTROL BL-2s Profile Selection 4. The LED will blink and then turn solid The speed control is factory set to Profile #1 (100% forward, brakes, and reverse). green (Low-Voltage Detection ACTIVE) or Patented Training Mode To disable reverse (Profile #2) or to allow 50% forward and 50% reverse (Profile #3), red (Low-Voltage Detection DISABLED).

  • Page 20: Driving Your Model

    RUNNING IN WET CONDITIONS result in poor performance and broken parts. Take care of your Your new Traxxas model is designed with water-resistant features model so that you can enjoy it for a long time to come. to protect the electronics in the model (receiver, servos, electronic •...
  • Page 21 Do NOT use pressure washer or other • The Traxxas TQ 2.4GHz transmitter is not water resistant. Do not high-pressure water. Avoid directing water into the bearings, subject it to wet conditions such as rain.
  • Page 22 DRIVING YOUR MODEL RECEIVER BOX: SETTING UP THE ANTENNA MAINTAINING A WATERTIGHT SEAL To set up the receiver antenna, To prevent loss of radio range, Removing and Installing Radio Gear remove the set screw with the do not kink or cut the black wire, The unique design of the receiver box allows the removal and included 1.5mm wrench.

  • Page 23: Adjusting Your Model

    ADJUSTING YOUR MODEL Once you become familiar with driving your model, you might need 1. Move the front shocks Motor Screw Position in Fixed Gear to make adjustments for better driving performance. to position 3 on the Adapter for Setting Gear Mesh: See sidebar on page 24 for Gearing suspension arms.
  • Page 24 ADJUSTING YOUR MODEL Centering Your Servo If you are worried that you might be over-geared, check the Gearing Compatibility Chart: The chart below shows If the trim controls on your transmitter seem off, you may need to temperature of the battery pack and motor. If the battery is extremely recommended gear combination re-center your servo.
  • Page 25 The offsets and dimensions in this model, remove the Only use silicone oil in the differentials. Traxxas offers various designed into the model’s wheels are intentional; therefore, Traxxas slipper gear assembly from...
  • Page 26 ADJUSTING YOUR MODEL Rear differential: Rear Differential Removal 1. Remove the two 3x20mm button-head screws that secure the top bumper mount to the differential case. 2. Turn the chassis over and remove the two 3x12mm countersunk 3x20 BCS crews that hold the bumper/skid plate to the bulkhead. The two front screws do not need to be removed.

  • Page 27: Maintaining Your Model

    If the bottom of the shock is leaking, then it 6. Check the tightness of the wheel nuts with a wrench. is time for a rebuild. The Traxxas rebuild kit for two shocks is 7. Check the operation of the radio system, especially the part #2362.
  • Page 28 MAINTAINING YOUR MODEL Suspension and slipper clutch assembly removal Your model was designed with ease of disassembly in mind. The entire front and rear suspension assemblies can be removed from the chassis fully intact with the removal of only a few screws. Refer to the exploded views included in the your model’s Service Support Guide for complete assembly diagrams.
  • Page 29 RUSTLER 4X4 • 29...
  • Page 30 ’ 6250 TRAXXAS WAY, MCKINNEY, TEXAS 75070 1-888-TRAXXAS 231201 67164-4-OM-EN-R02...

This manual is also suitable for:

67164-4

Table of Contents