Installing The Battery Pack; Power-Up Modes - Toshiba Satellite A80-127 User Manual

Installing the battery pack

To install a battery pack, follow the steps below.
The battery pack is a lithium ion battery, which can explode if not properly
replaced, used, handled or disposed of. Dispose of the battery as required
by local ordinances or regulations. Use only batteries recommended by
TOSHIBA as replacements.
1. Turn the computer's power off.
2. Disconnect all cables connected to the computer.
3. Hold the battery pack so that the label faces down and the connectors
on the battery face the connectors on the computer.
4. Gently press the battery into the battery bay until the latch clicks into
place.
5. Lock the Battery Pack Lock and Battery Pack Release Latch to secure
the installation.

Power-up modes

The computer has three power-up modes:
■
Hibernation (saves data in memory to the hard disk)
■
Standby (Power remains on, saving data in RAM, but the CPU and all
other devices enter sleep mode.)
■
Boot (does not save data in memory)
Refer also to the section Turning off the power in Chapter 3, Getting Started.
Toshiba A80
2
Installing the battery pack
Power System
1
Battery
6-12