Table of Contents
Advertisement
Transferring Data
IV
:
PRESS DONE KEY TO EXIT
(CODE)>(L)-(> (ENTER
-
|
(Select RECEIVE)
CPA-b is ready to receive the
data.
(BP) or
ENTER
(Select Y)
ena
the data.
PRESS DONE KEY TO EXIT
(ENTER)
ePress | ENTER
within 30
seconds, or "LINK ERROR"
will occur.
eTo stop transferring data,
press
on either CPA-a
or CPA-b.
The data on the way is
transferred to CPA-b (receiver).
(4) On both CPAs
FEB.25,1994 FRI
Return to initial display.
09:12 PM
IS
@Before starting the transfer, make sure that the memory size of CPA-b
is larger than the existing data size of CPA-a. If not, the existing data
of CPA-b will all be cleared. If necessary, delete some records in
CPA-a.
Se
elf KX-RC100 is the sender, the data of Second Bank, Cash, Card
#6~10 and Phone will not be sent to CPA (KX-RC95).
IG
elf KX-RC105 is the sender, the data of Second Bank, Cash and Card
#6--10 will not be sent to CPA (KX-RC95).
G^
@'LINK ERROR?" will occur in the following cases:
1. If the baud rate is different between the CPA units.
2. If the CPA units are not connected correctly by the interface cable.
3. If address data is sent to a CPA which has phone data.
4. If phone data is sent to a CPA which has address data.
IS
eWithdrawals and service charges are entered on a KX-RC100/105 by
entering O as the check number. When this data is transferred to a
KX-RC965 it will be included when you make a report and select the
check number as "A", "S" or "O" (p. 24, 41). To search for this type
of record on a KX-RC95, press
and enter "O" as the check
number (p. 28).
49
ejeg
Butue
LE
ejeg
6uuo
Advertisement
Table of Contents
