In Case Of Difficulty - Kenwood KR-V126R Instruction Manual

Hide thumbs Also See for KR-V126R:
Table of Contents

Advertisement

In case of difficulty
"Symptom —S—=—~—'idaCS*C"'"'C'*' SCS
No power, no sound.
1. Power cord not plugged in.
2. Poor connection at wall outlet.
Power outlet inactive.
1. Check plug contact.
2. Check outlet using a lamp or other
appliance (outlet may be controlled
by a wall switch).
stays with speaker, have speaker
checked.
The antenna circuit is set to the CATV | Press the
key to switch the
position. (The
indicator lights | ANT circuit from CATV to FM. Check
in the display window.)
that the
indicator goes off in
the display.
Switch the input selector to the source
other than TAPE 1.
FM
broadcast
too
noisy. Sufficient
reception is impossible.
The Input Selector TAPE
7 button is
pressed.
(The TAPE
1 indicator
lights in the
display.)
@ Dubbing from TAPE 2 to TAPE 1
is impossible.
;
@ Graphic equalizer recording does
not function
when
recording
on
tape.
Graphic equalizer recording is impos-
sible in the VIDEO DUBBING mode.
Press the AUDIO
INJECTION
key to
ON.
Check that the AUDIO
INJECTION
indicator lights up, then press the EQ
REC key.
A pair of speakers is not connected to | Connect
the two
pairs of speakers
the A or B speaker terminals.
correctly to both
A and
B speaker
terminals. Or, switch the Speaker Se-
lector to A or B position to which the
speakers are connected.
@ Surround switch is set to OFF.
@ Press the Surround key ON.
@ When
the volume
of the
front |} @ Adjust the volume level of the rear
speakers is set at the lower level,
speakers to its positive side.
the volume level of the rear speak- | @ Change the playback source to the
ers is indicated at the further lower
stereo or surround source.
level.
Monaural source is used.
Batteries are not loaded. Or batter-
ies are exhausted.
;
@ The remote sensor is obstructed.
The AUDIO
INJECTION
key is not
pressed ON.
No sound is heard with the Speaker
Selector set to the "A+B"
position.
No sound from the rear speakers.
@ Replace
the
batteries
with mew
ones.
@ Remove
the obstacle from the re-
mote sensor.
Remote control does not function.
Occurs during AM
reception only
High-frequency whistle
especially at
night.
Intermittent buzz or cracking sound.
Interference from TV set.
Turn off TV set, if problem disappears
try relocating TV set.
Lightning.
No remedy.
Fluorescent lamps starting.
Try reversing AC plug.
Appliance or furenance starting.
Try reversing AC plug.
Occurs during FM reception only
Cause
_
Remedy
Hiss
that
gets
worse
in stereo | Very weak antenna input signal.
Consider an outdoor antenna installa-
reception.
tion. In areas remote from the trans-
mitter
a 5 to 8 element antenna
de-
signed exclusively for FM is sucg est-
ed.
Automobile ignition noise, especially | Review antenna
installation. Sit
the
evident when receiving weak signals. | antenna
as far from
the
strest
as
possible and use coaxial cable.
STEREO indicator fails to light during | Another possible effect of a very weak | Antenna system needs attentio: (see
stereo broadcast.
signal.
above).
Rhythmic static or popping noises.
KR-V126R/KA-V106R/KR-V86R i)
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kr-v106rKr-v86r

Table of Contents