Table of Contents
Advertisement
The maximum length of the cord is 100 m. If the
d
length of the cord exceeds 50 m, use a wire size
greater that 0.5 mm
Disassembling of the remote
controller
a
Front case
Lever carefully the box open using a screw
b
driver, etc.
c
Remote control box body
When the remote control box is
installed with the cord buried.
Procedure of installation
• Fix the under plate on the switch boy by screws
(Local supply). In this case, fit the under plate on
the wall, and be careful of deformation.
• Receive the remote control cord in the switch
box.
• Hook the remote control unit on the under plate.
Face of wall
a
Under plate
c
Screw (Local
e
supply)
Lower notch
g
2
.
Upper notch
b
Remote control
d
unit
Remote control
f
cord
Switch box (Local
h
supply)
When the remote control box is
installed with the cord exposed.
Procedure of installation
• Fix the under plate on the wall by self tapping
screws (accessory).
• Make a slit (Part A) at the top side of the remote
control box by nipper.
• Rout the cord as shown in the following figure. In
this case, push the cord into the around of case
(Part B).
• Hook the remote control unit on the under plate.
Remote control
a
cord (Part A)
Face of wall
c
Under plate
e
Upper flange
g
Lower notch
i
Fixing of remote control cord
• Fix the cord clamps on the wall by Ø3 tapping
screws (Local supply).
• Fix the remote control cord.
Cord clamp
a
Refrigerant Piping
• Braze the joints
INSTALLATION
Remote control
b
unit
Upper notch
d
Tapping screw
f
(Local supply)
Push hand (Part B)
h
15
Advertisement
Table of Contents
