Pioneer VSX-605S Operating Instructions Manual page 25

Calling up the tuner display.
1. Press the TUNER button of the input selector.
2. Press the GUIMODE button on this unit or the GUI button
on the remote control.
TUNER operation indications are displayed.
cD) Channel indication:
Indicates the current channei.
2 Frequency indication:
Indicates the current frequency.
@ -4, > buttons:
Use to raise or lower the frequency.
@ BAND button:
Switches between FM/AM. The band changes each time you
Press this button, and is displayed next to the frequency
indication.
illustration shows U.S. and Canadian models.
© MEMORY button:
Use to memorize stations.
You can only press this button when a channel list is
displayed.
© Channel list:
Frequencies memorized in each channel are displayed. Press
a number button, and that channel's frequency is received.
@ NEXT button:
Switches between channel lists. There are a total of thirty
channels, from 1 to 30, displayed 10 at a time on three lists
which change each time you press the button as follows.
as 4-10 19-20 21-30 7
1. Move the cursor to BAND, and select FM or AM.
The band changes each time you press the ENTER button.
2. Move the cursor to » or <4, and press the ENTER button
to raise or lower the frequency as desired.
@ One Step Tuning:
Press the ENTER butten and release quickly. The frequency will
change by one step each time the button is pressed. Press as
many times as necessary to tune in the desired station.
@ Auto Tuning:
Press the ENTER button until the frequency starts to change
{about 1 sec.}, then release it. The tuner automatically searches
for a broadcasting station and stops when one is found.
NOTE:
When the signal level is too weak for reception, the unit cannot
perform Aute tuning. in this case, change to Manual tuning.
® High Speed Manual Tuning:
Keep the ENTER button pressed. The frequency changes
continuously, and stops when the button is released.
You can preset up to 30 FM/AM stations for easy recall.
FREQUENCY PRESETTING
1. Press N E X T to switch to the desired channel list.
{1-10, 11-20 or 21-30)
2. Tune in the desired station.
Refer to "MANUAL/AUTO TUNING" procedure.
in addition to station frequencies, the MPX MODE can also
be preset (FM only).
Switch to the MPX MODE using the MPX MODE button on
this unit. (No indications are displayed.)
3. Press the MEMORY button.
Channel indications flash.
4, Select the channel you want to memorize from the
channel list.
This memorizes the frequency.
To memorize other stations, repeat steps 2 through 4 or 1
through 4.
25
<ARB7059>