Table of Contents
Advertisement
@ CENTER PRE OUT jack
When a separate power amplifier is used to drive the surround
center speaker, connect the power amplifier to this jack.
TWO VOLTAGE SELECTORS switches
(Muiti-voltage model only)
See page 4.
(9: PHONO input jacks
Connect to the output cables from a turntable.
@ GND terminal
Connect the turntable ground lead to this terminal.
NOTE:
This is used to decrease noise and does not serve as a complete
ground.
4) TAPE 2 MONITOR jacks
Connect to audio components such as a second cassette deck or
a graphic equalizer.
a CD input jacks
Connect to the output jacks of a compact disc player.
43 LD/DVD input jacks
Connect to an LD player's output jacks (audio, video) or a DVD
player's output jacks (audio, video).
(4 VCR/TAPE 1 jacks
Connect to a VCR or the first cassette deck. With a VCR, also
connect the video jacks.
49 CHANNEL STEP switch
(Multi-voltage modei only)
See page 4.
16 SUB WOOFER PRE OUT jack
if you want to boost the low frequencies, connect to a subwoofer
power ampiifier.
a CENTER SPEAKER terminais
Connect the center speaker to these terminals.
NOTE:
Do not allow any of the cord's conductors to protrude from the
terminals or touch any other conductors.
Malfunctions or
breakdowns may occur when conductors come into contact with
each other. Use a center speaker with an impedance of 8Q to 16
2
REAR PANEL FACILITIES
a& REAR SPEAKERS terminalis
Connect the rear speakers te these terminals.
NOTES:
@ Do not aliow any of the card's conductors to pratrude from
the terminals or touch any other conductors. Malfunctions or
breakdowns may oceur when conductors come into contact
with each other. Use rear speakers with an impedance of 82
to 16.
® Be sure to connect two speakers (L, R). There will be no sound
if only one speaker is connected.
42 FRONT SPEAKERS terminals
A
:Connect to the first set of speakers.
8
;Connect to the second set of speakers.
NOTE:
Do not allow any of the cord's conductors to protrude from the
terminals
or touch
any other conductors.
Malfunctions
or
breakdowns may occur when conductors come into contact with
each other. Use front speakers with an impedance of 8Q to 16Q.
@ Power cord
@ AC OUTLET
(Multi-voltage, U.S. and Canadian models only}
{U.S. and Canadian models)
[SWITCHED 100 W (0.8 A) MAX]
Power supplied through this outlet is turned on and off by the
receiver's POWER switch. Total electrical power consumption of
connected equipment should not exceed 100 W (0.8 A).
{Multi-voltage model)
[SWITCHED 100 W MAX]
Power supplied through this outlet is turned on and off by the
receiver's POWER switch. Total electrical power consumption of
connected equipment should not exceed 100 W.
NOTES:
® This unit shouid be disconnected by removing the power plug
from the walf socket when not in regular use, e.g. when on
vacation.
®@ Do not connect appliances with high power consumption such
as heaters, irons, or television sets to this AC OUTLET in order
to avoid overheating and fire risk. This can cause the receiver
to malfunction,
CAUTION:
BO NO CONNECT MONITOR OR TV SET.
13
<ARB7059>
Advertisement
Table of Contents
