A350/A350D
Point to note about memory module error
If you install a memory module that is not compatible with the computer, the
Power indicator will flashes in the following ways;
If there is an error in only Slot A or no memory module is inserted in
Slot A: repeatedly flashes amber twice, then green.
If there is an error in Slot B: repeatedly flashes amber, then green twice.
If there are errors in both Slot A and Slot B: repeatedly flashes amber
twice, then green twice.
In all instances you should shut down the computer and remove the
incompatible module(s).
Use a #0 point Phillips screwdriver to remove and fasten the screws - the
use of an incorrect screwdriver can damage the screw heads.
Installing a memory module
The computer contains slots for two memory modules, one positioned
immediately over the other - the procedures are the same for installing
either module.
1. Shut down the computer - make sure the Power indicator is off (refer to
the
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
8-8
Turning off the power
section in Chapter 3,
Getting Started
if
User's Manual