Sherwood R-925 Operating Instructions Manual page 14

Adjusting the speaker settings
Select the desired subwoofer mode.
« Adjusting the setting of the center speaker and the
subwoofer connected.
SPEAKER
MODE
i
» Each time this button is pressed,the subwoofer
mode changes and flickers as follows;
Press the SPEAKER MODE button for more
than 2 seconds to enter the center speaker
mode.
SPEAKER
MODE
i
¢ In the THEATER, HALL, STADIUM, CHURCH or
normal stereo mode, it will become the subwoofer
mode directly.
YES : When using a subwoofer.
NO : When not using a subwoofer.
Memorize the desired subwoofer mode
while it flickers.
Select the desired center speaker mode.
SPEAKER
MODE
* Each time this button is pressed, the center speaker mode
changes and flickers as follows;
MEMO / ENTER
i
¢ If the subwoofer display goes off, repeat again from
the above step 2.
LARGE : When using a relatively large center speaker.
|
SMALL : When using a relatively small center speaker.
NONE: When not using a center speaker.
* In the Dolby 3 Stereo mode, the NONE mode can not be
selected.
Memorize the desired center speaker mode
while it flickers.
Checking the speaker setting
MEMO / ENTER
:
* The desired center speaker mode is memorized and
then it becomes the subwoofer mode.
If the center speaker display goes off, repeat again
from the above step 2.
SPEAKER
MODE
zz
¢ Each time this button is pressed briefly, the setting
of the center speaker or the subwoofer is displayed.
:
|