To Adjust Throttle Control Cable; To Adjust Carburetor - Craftsman TILLER 917.29332 Owner's Manual

ENGINE
Maintenance, repair, or repracement of the
emission control devices and systems,
which are being done at thQ customers
expense, may be performed by any non-
road engine repair establishment or indi-
vidual. Warranty repairs must be per-
formed by an authorized engine manufac-
turer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
• The throttle Control has been preset at
the factory and adjustment should not
be necessary. If adjustment is neces-
sary, proceed as follows:
• With engine not running, move remote
throttle control lever to =FAST" position.
• If throttle lever on engine touches high
speed stop, no further adjustment js
necessary. If throttle lever does not
touch high speed stop, continue with
adjustment procedure.
• Loosen cable clamp screw.
• Move throttle lever up until it touches
high speed stop, and hold in this posi-
tion.
• Tighten cable clamp screw securely.
Fuel Tank
/ Clamp
, Screw
TO ADJUS T CARBURETOR
The carburetor has been preset at the fac-
tory and' adjustment should not be neces-
sary. However, engine performance can
be affected by differences in fuel, tempera-
ture, altitude or load. If the carburetor
does need adjustment, contact your near-
est authorized service center/department
IMPORTANT: Never tamper with the
engine governor, which is factory set for
proper engine speed. Overspeeding the
engine above the factory high speed set-
ting can be dangerous. If you think the
engine-governed high speed needs adjust-
ing, contact your nearest authorized ser-
vice center/department, which has the
proper equipment and experience to make
any necessary adjustments.
Governor
Control
Lever
18