Craftsman TILLER 917.29332 Owner's Manual page 21

PROBLEM
Engineoverheats
Excessive bounce/
difficulthandling
Soilballsup or
clumps
Enginerunsbut
tillerwon't move
Enginerunsbut
laborswhentilling
Tinesskipover
ground
CAUSE
1. Lowoillevel/dirty oil.
2. Dirtyengine airscreen.
3. Dirtyengine.
4. Partially p lugged muffler.
5. Improper carburetor
adjustment.
1. Ground t oo
dry and hard.
2. Depth stake
incorrectly adjusted.
1. Ground too wet.
1. "line controlis not engaged.
2. V-belt not correctly adjusted.
3. V-belt is off pulley(s).
1. Tilling too deep.
2. Throttle control not propedy
adjusted.
3. Carburetor out of adjustment.
1. Drag Stake not lowered in
forward rotating till mode.
2. Improper filling mode.
CORRECTION
1. Check oil level/change oil.
2. Clean engine air screen.
3. Clean cylinderfins, air screen, muf
tier area.
4. Remove and clean muffler.
5. Adjust carburetor to richer posi
tion.
1. Moisten ground or wait for more
favorable soil conditions.
2. Adjust depth stake.
1. Wait for more favorable soil condi
tions.
1. Engage tine control.
2. Inspect/adjustV-belt.
3. Inspect V-belt.
1. Set depth stake for shallower till
ing.
2. Check throttle controlsetting.
3. Make necessary adjustments.
1. Lower Drag Stake
2. FonNard rotatingtine drive should
only be used for soft ground or for
soil that has already been tilled.
21