Basic Operation; To Play A Compact Disc; To Remove A Disc - Pioneer PD-T305 Operating Instructions Manual

rc
| BASIC OPERATION
POWER
SBLOFF/ —ON
hal
8
U
C
=
Operations indicated by the [ q
mote control unit {(PD-T505 only}.
mark are performed with the re-
@ All names of controls, indicators and front panel are accompa-
nied by a number in a circle.
To play a compact disc
1. Press POWER switch @) to turn on power to the
player.
2. Press OPEN/CLOSE button @).
@ Place a compact disc on the tray.
3. Press PLAY button @.
To begin playback from the second disc:
® Press the DISC Ii button @®.
To temporarily interrupt playback:
® During playback, press PAUSE button @ (the PAUSE indicator
LOU] will Hight).
® To recammence playback, press either PAUSE button @ again,
or PLAY button @.
To stop playback:
® Press STOP button @.
To remove a disc
® Reverse the procedures for disc ioading.
1. Press OPEN/CLOSE button @).
2. Remove the disc and return it to its protective
case.
3. Press OPEN/CLOSE button @) to close the disc
tray.
4, Press POWER switch ( to turn off the power.
Regarding handling of compact discs:
@ This player is designed to play back compact audio discs featur-
ing the mark shown below.
§ When holding discs, do not touch their signal surfaces. Hold the
edges, or one edge and the center hole.
& Do not affix tape or seals to the disc's label surface, and take
care to avoid scratching either of the disc's surfaces.
@ Discs revolve at high speeds inside the player; do not attempt
to play discs which are damaged (cracked or severely warped
discs).
DIGITAL AUDIO
CAUTION:
® When setting an 8 cm CD single, do not use the 8cm CD single
adapter.
® Be sure to insert discs with the label surface facing up.
® De not touch the disc's signal surface (the side reflecting a "rain-
bow" pattern, opposite the label side}.
@ Never attempt to load both 8 cm and 12 cm discs together, since
disc damage or other malfunctions may result. Always load only
one disc at a time.
9
«<PRB1120>
En