Table of Contents
Advertisement
Tuning to a Memory Channel
l.
Press MR.
2.
Rotate M-CH, or press UP or DOWN on the microphone, to
select the desired memory channel.
Checking Priority Channel 1
To have the HTX-212 periodically "look back" at Memory Channel
1 to check for a transmission, press F then ALM. @ appears on the
display. The HTX-212 looks back at Memory Channel 1 every 4, 8,
12, or 16 seconds. If there is a transmission, the HTX-212 beeps to
let you know to tune to it, if desired.
Follow these steps to change the look-back time.
l.
Press VFO.
2.
Hold F for at least 1 second. FUNC flashes. Then press MR.
3.
Repeatedly press A until the HTX-212 displays Lb and the
current look-back time.
4.
Rotate TUNE, or press UP or DOWN on the microphone, to
select the desired look-back time (4, 8, 12, or 16 seconds).
5.
Press MR to save the setting.
Scanning Memory Channels
To set the HTX-212 to scan all memory channels, hold MR for at
least 1 second. M-CH flashes, and the HTX-212 scans the memo-
ries. The HTX-212 stops when it encounters a transmission. It
resumes scanning according to the saved scan settings (see "Set-
ting the Scan Options" on Page 21).
Clearing
a Memory Channel
You can clear any memory channel except Memory Channel 1 and
the calling-frequency memory.
1.
Tune to the memory channel you want to clear.
2.
HoldF
for at least 1 second. FUNC flashes.
3.
Press MR. АП settings are cleared from the memory channel.
Advertisement
Table of Contents
