Operating Audio Components; Compu Link Remote Control System - JVC RX-308BK Manual

-RX=308BK
RX-309TN
Operating Audio Components
PO MAB If RTs
WoWE IT WS ie CIN
'Il/Remote /iil
Control System
Remote Control
Automatic Source esa of
Selection
Synchronized Recording
Automatic Power ON/OFF
Page 18
4-20 (No.20375)
COMPU LINK Remote Control'System -:
The COMPU LINK remote control system lets you operate the récéiver and JVC components
«from the remote supplied with this receiver. Control signals for JVC audio components are
preset in the receiver's remote control.
Connecting the COMPU LINK SYNCHRO-3 jacks on the back of the receiver will allow you
to use the four functions below.
~ Youcan-control all components via the REMOTE SENSOR on the receiver using the receiver's
remote e control: For details; see page 19. '
IMPORTANT! Point the remote control directly at the REMOTE SENSOR on the
* receiver.
When you press play on a component or the remote, the component begins playing immedi-
ately. On the other hand, if you select anew source onthe receiver or the remote, the component
begins playing immediately, but the e Brevionsly selected source continues playing without
sound for a few seconds.
Synchronized recording means the tape deck starts recording as soon as a CD or record begins
playing.
To use synchronized recording, follow these steps:
Step 1 Puta tape in the deck, and a disc in the CD player or on the turntable.
Step 2 Press the REC and PAUSE button on the tape deck at the same time. This puts the
tape deck in the REC/PAUSE state.
IMPORTANT! If you do not press the REC button and PAUSE button together, the
synchronized recording feature will not operate.
Step 3 Press the PLAY button on the CD player or turntable.
As soon as the disc starts playing, the tape deck starts recording. When the disc ends, the tape
deck switches back to the REC/PAUSE mode, and stops 4 seconds later.
NOTES:
¢ During synchronized recording, the CD or PHONO button is activated. Other
SOURCE buttons are disabled to prevent recording failure.
* Ifyour CD player is operated in the PROGRAM mode, a 4-second mute is recorded
between tracks to enable the music scan feature of your tape deck to work.
¢ If the power of any component is shut off during synchronized recording, the system
will not operate properly. In this case, you must start again with step 1.
The CD player and cassette deck are turned on and off along with the receiver.
NOTE: This function has been added to COMPU LINK-3 (Enhanced COMPU LINK),
an upgraded version of COMPU LINK-1. Refer to your JVC component manual for
details.