Table of Contents
Advertisement
4.2 Terminal Selection
Functions associated with the input and output terminals on the inverter's control circuit board can
be selected via the operating panel by using the procedures described in this section.
4.2.1 Selection of input terminals [
I.cb ]
1)
Seleciton of control terminals SS1, JOG/SS2, and AD2/SS3
Setting
on
:.cb
Function
0
SS2 and SS3 (for a 7 -speed run)
1
JOG and SS3 (for jogging and 3-speed runs)
2
SS2 and AD2 (for acc./dec. 1,2 runs coupled with 3-speed runs)
3
JOG and AD2 (for jogging and acc./dec. 1,2 runs)
• For details of the procedure for selecting input terminals via the operating panel, refer to Section
3.1.1 (page
22). Select function number 8 for the terminal selection operation.
I
2)
Table 4.1 below specifies the ON or OFF positions of control terminals SS1, JOG/SS2, and AD2/
SS3, and shows their respective operating frequencies.
Advertisement
Table of Contents
