Table of Contents
Advertisement
FRONT PANEL FACILITIES
DISPLAY SECTION
Baa + 88
Eres]
,,, [STEReS)
mone (rue |
3 SD
a
@® Level/Tone meters
display switches, and the OVER LOAD indicator lights.
@ Character display/Balance meter
display.
Top is front.
Bottom is rear.
© DSSS indicator
Lights when the DSSS button is ON.
(@®) DIRECT indicator
This fights when the Direct mode is switched ON.
© TAPE 2 indicator
Lights when the TAPE 2 MONITOR button is in the ON position.
© SURROUND MODE indicators
@ Meter mode indicator
indicates the display modes mentioned in ©.
@ SPEAKERS indicators
Shows which speaker system (or systems) are switched ON.
@ INPUT ATT indicator
This lights when the INPUT ATT button is switched ON.
22
<ARB1420>
@ REC selector indicators
* The recording source selected with the REC SELECTOR button is
usually displayed.
® Station call no./Delay time/Surround effect/Enhancer level display
* Usually, the STATION indicator and "'ch'' light to display the station
call number.
* When adjusting surround delay time, the DELAY indicator and ms
light to display delay time.
* When adjusting enhancer level, enhancer level from — 50 to 50 is
displayed.
© Tuning indicators
broadcasts is also monaural.
this lights when receiving an FM stereo broadcast.
TUNED:
Lights when a station is tuned.
@ CENTER MODE indicators
These display the center mode (NORMAL, WIDE, PHANTOM) during
THEATER or DOLBY PRO LOGIC SURROUND.
With DOLBY 3CH LOGIC, you can select NORMAL or WIDE; but you
cannot select PHANTOM.
STEREO:
Waming indication:
Display section indicators will flash to indicate that operation is not
| possible in a particular situation when you press a button. With Multi-
Room & Source, the button itself flashes.
Advertisement
Table of Contents
