Table of Contents
Advertisement
REAR PANEL FACILITIES
@ CENTER AMP jacks
IPOWER INI
When a separate preamplifier is used for surround center speaker and
this unit is used as a power amplifier, connect the preamplifier to this
jack.
[PRE-OUT]
When a separate power amplifier is used to drive the surround center
speaker, connect the power amplifier to this jack.
REAR AMP jacks
(PRE OUT]
When a separate power amplifier is used to drive the rear speakers,
connect the power amplifier to these jacks.
[POWER IN]
When a separate preamplifier is used for rear speakers and this unit is
used as 4 power amplifier, connect the preamplifier to these jacks.
@ CENTER SPEAKER terminals
Connecting the surround center channel speaker system.
Speaker impedance:
NOTE:
Do not allow any of the code's conductors to protrude from the
terminals or touch. any other conductors. Malfunctioning or breakdown
may occur when conductors come into contact with each other.
@ REAR SPEAKERS terminals
Connect the rear speakers to these terminals.
Speaker impedance
Connect speaker systems with a nominal impedance of between 8 and
162,
NOTE:
Do not allow any of the cord's conductors to protrude from the terminals
or touch any other conductors. Malfunctioning or breakdowns may
occur when conductors come into contact with each other.
@ MULTI-ROOM SPEAKERS terminals
Connect to the Multi-room speakers.
Speaker impedance
NOTE;
PHONO LEVEL control
Use to adjust turntable input level. If distortion occurs when you are
using a high-output cartridge, adjust the volume fevel until it's the same
as another input, such as TUNER.
@) GND terminal
Connect the turntable ground lead to this terminal.
Audio INPUT jacks
Connect to turntable.
'Connect to compact dise player.
Connect to the audio output jacks of an additional
audio component.
24
<ARB1420>
@LD jacks (input)
{VIDEO iN}
[AUDIO IN {L, R)I
@TV jacks (input)
[VIDEO IN]
Connect the TV tuner's VIDEO OUTPUT to this jack.
{AUDIO IN {L, R)]
Connect the TV tuner's AUDIO OUTPUT to these jacks.
VIDEO jacks {input)
Connect the output jacks of video components.
For example, connect a playback-only VCR or a video camera.
VIDEO OUT TO MONITOR TV jacks (output)
Use to connect a TV monitor or a TV set with video input terminals for
watching program materials from a VCR or Video disc player (LD player)
connected to this unit.
@ FRONT AMP jacks
[PRE-OUT}
When a separate power amplifier is used to drive the front speakers,
connect the power amplifier to these jacks.
{POWER IN}
When a separate preamplifier is connected and this unit is used as power
amplifier, connect the preamplifier to these jacks.
@ MULTI-ROOM
& SOURCE
REMOTE
IN jack
When using the MULTI-ROOM & SOURCE function, connect to the
separately sold MR-100 Multi-Room remote contro! unit. (See pages
16, 17)
@ CONTROL IN, OUT jacks
Used for system control with other Pioneer components bearing the
mark.
IN:
For connection
from
the CONTROL
OUT
jack of another
component {TV, etc.).
OUT:
For connection to the CONTROL IN jack of another component.
NOTE:
The receiver's remote sensor does not function when a plug is inserted
in the IN jack. To operate, point the remote control unit at the remote
sensor on the component ta which the receiver's IN jack is connected,
When using
the MR-100
(5
Receiver
b-
Pioneer component
bearing the
mark.
MR-100
Remote control unit
To the CONTROL IN
Jack of the Pioneer
component bearing
the 58 mark.
Advertisement
Table of Contents
