Table of Contents
Advertisement
• Pushdownonthestarterbuttonuntilthe
enginestarts.Donotcrank
for more than
10 seconds at a time. This electric starter
is thermally protected. If Overheated it will
stop automatically and can be restarted
only when it has cooled to a safe
temperature (a wait of about 5 to 10
minutes is required).
• When the engine starts, release the
starter button and move choke lever to
"1/2 choke" position. When engine runs
smoothly, move choke lever to =No
Choke" Pos!tion.
• Disconnect the power cord from the
receptacle
first and then from the switch
box on engine.
NOTE: Allow the engine to warm up for sev-
eral minutes before blowing snow in tem-
peratures below 0°F.
• Run the engine at full throttle ,_
(FAST)
when throwing snow.
TO STOP ENGINE
• To stop engine, move the throttle control
lever to Q (STOP) position and remove
key. Keep the key in a safe place. The
engine will not start without the key.
NOTE: DO NOT turn key.
TO START ENGINE (Recoil Starter)
Be sure that the engine has sufficient oil.
The snow thrower engine is equipped with a
recoil starter. Before starting the engine, be
certain that you have read the following in-
formation:
COLD START
• Be sure the auger drive and traction drive
levers are in the disengaged (released)
position.
• Move the throttle control to '_
(FAST) po-
sition. See figure on page 9 for location.
• Remove the keys from the plastic bag. In-
sert one key into the ignition slot. Be sure
it snaps into place. DO NOT TURN KEY.
Keep the second key in a safe place.
• Rotate the choke knob to H choke On
position. See figure on page 9.
• Push the primer button, see figure on page
9, while covering the vent hole as fallows:
(Remove finger from primer button be-
tween primes).
Do not prime if temperature is above
50oR
Two times if temperature is 50°F to
15°F.
Four times if temperature is below
15"1:.
• Pull the recoil starter handle rapidly. Do
not allow the handle to snap back, but al-
low it to rewind slowly while keeping a
firm hold on the starter handle.
• As engine starts warms up move choke
lever to "1/2 choke" position. When
engine runs smoothly, move choke lever
to "No Choke" Position.
NOTE: Allow the engine to warm upfor
several minutes before blowing snow in
temperatures below 0°F.
• Run the engine at full throttle ,_p (FAST)
when throwing snow.
WARM START
If restarting a warm engine after a short
shutdown, leave choke at (OFF) and do
not push the primer button. If the engine
fails to start, follow the Cold Start instruc-
tions above.
FROZEN
RECOIL
STARTER
If the starter Is frozen and will not turn
engine:
• Pull as much rope out of the starter as
possible.
• Release the starter handle and let it snap
back against the starter.
If the starter still fails to tum engine, repeat
the two previous steps until the starter en-
gages. Then continue with the directions for
cold start.
To help prevent possible freeze-up of recoil
starter and engine controls, proceed as fol-
lows after each snow removal job.
• With the engine running, pull the starter
rope hard with a continuous full arm
stroke three or four times. Pulling of
starter rope will produce a loud clattering
sound. This is not harmful to the engine
or starter.
• With the engine net running, wipe all
snow and moisture from the carburetor
cover in area of control levers. Also move
throttlecontrol,choke control,and starter
handle several times.
13
Advertisement
Table of Contents
