Frigidaire PCFG3670AF Installation Instructions Manual page 11

36" FULL GAS RANGE INSTALLATION INSTRUCTIONS
To convert the appliance to propane gas see
"Conversion to Propane gas (LPG)". The conversion
must be done by a qualified technician or installer.
Use a flexible gas pipe with a length of at least 5 ft
(1.5 m). The gas inlet to the unit is located at the
back right of the appliance. Install the pressure
regulator (supplied with the unit) on the gas inlet.
Install the gasket (supplied with the unit) between
the inlet and the regulator. Position the regulator so
that the cap D is easily accessible. Tighten the nut
on the gas inlet so that it is hand tight plus 1/3 turn.
Connect the gas pipe to the regulator using Teflon
tape or pipe-joint compound (resistant to propane
gas and natural gas). Turn so that it is hand tight
plus 1/3 turn. Do not exceed 1 turn for alignment, to
prevent possible damage to the gas pressure
regulator.
1 Gas inlet (attached to the appliance).
2 Gasket.
3 Pressure regulator.
CAUTION
Do not allow regulator to rotate on
pipe when tightening fittings.
WARNING
Do not attempt to adjust the pres-
sure regulator, except when converting to propane.
Adjustments could lead to leaks or cause incorrect
gas pressure being supplied to the appliance.
Burners and nozzles technical tables
Cooktop burners:
Burner power and bypass table
Burner
1
No.
Max.
18000
Power
(BTU)
Min.
750
Power
(BTU)
Bypass
75 / 26
(mm)
Natural gas nozzles table (Pressure in W.C.P.: 5")
Burner
1
No.
Ext.
180
nozzle
number
Int. noz-
75
zle
number
LPG nozzles table (Pressure in W.C.P.: 10")
Burner
1
No.
Ext.
115
nozzle
number
Int. noz-
48
zle
number
11
2
12000
750
55 / 26
2
135
75
2
91
48