Installation Of The Product - McCulloch 967059700 Operator's Manual

3.3.5 Work area examples
D
B
• If the charging station is put in a small area
(A), make sure that the distance to the
boundary wire is at a minimum 3 m / 10 ft.
• If the work area has a passage (B), make
sure that the distance to the boundary wire
is at a minimum 2 m / 6.6 ft. If the passage is
smaller than 2 m / 6.6 ft., install a guide wire
through the passage. Minimum passage
between the boundary wire is 60 cm / 24 in.
• If the work area has areas which are
connected by a narrow passage (B), you
can set the product to leave the guide wire
after a certain distance (C). The settings can
Remote start 1 on page 23 .
be changed in
• If the work area includes a secondary area
To make a secondary area on
(D), refer to
page 18 . Put the product in the secondary
Proportion .
area and select
1054 - 001 -

3.4 Installation of the product

3.4.1 To install the charging station
1. Read and understand the instructions about
the charging station. Refer to
A
where to put the charging station on page
15 .
2. Put the charging station in the selected area.
3. Connect the low-voltage cable to the
charging station.
4. Put the power supply at a minimum height of
30 cm / 12 in.
C
5. Connect the power supply cable to a
100-240V outdoor power outlet.
WARNING: Obey national regulations
about electrical safety.
To examine
min 30 cm / 12"
WARNING: Do not put the power
supply at a height where there is a
risk it can be put in water. Do not
put the power supply on the
ground.
WARNING: Do not encapsulate
the power supply. Condensed
water can harm the power supply
and increase the risk of electrical
shock.
WARNING: Applicable to USA/
Canada. If power supply is
installed outdoors: Risk of Electric
Shock. Install only to a covered
Class A GFCI receptacle (RCD)
that has an enclosure that is
weatherproof with the attachment
plug cap inserted or removed.
Installation - 19