AEG LFR6194O2V User Manual page 25

The ProSense estimation starts at the
end of the countdown.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Inicio/Pausa button to pause
the appliance. The related indicator
flashes.
2. Touch the Inicio Diferido button
repeatedly until the display shows
3. Touch the Inicio/Pausa button again to
start the programme immediately.
Changing the delay start after the
countdown has started
To change the delay start:
1. Touch the Inicio/Pausa button to pause
the appliance. The related indicator
flashes.
2. Touch the Inicio Diferido button
repeatedly until the display shows the
desired delay time.
3. Touch the Inicio/Pausa button again to
start the new countdown.
12.6 Starting a programme
Touch the Inicio/Pausa button to start the
programme.
The related indicator stops flashing and stays
on.
The programme starts, the door is locked.
The display shows the indicator
The drain pump can operate shortly
before the appliance fills water.
12.7 The ProSense System load
detection
The programme duration in the display is
referred to a medium/high load.
After touching the Inicio/Pausa button, the
maximum declared load indicator goes off,
the indicator
System starts the laundry load detection:
1. The appliance detects the load in the first
30 seconds, the indicator
digit area shows
rotates shortly.
2. At the end of the load detection, the
indicator
programme duration will be adjusted
accordingly and could increase or
decrease. After further 30 seconds, the
water filling starts.
.
At the end of the load detection, in case of
drum overload, the indicator
flashing in the display.
In this case, for 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Inicio/Pausa button to start the
programme again. The ProSense System
phase can be repeated up to three times (see
point 1).
Important! If the laundry amount will not be
reduced, the washing programme starts
anyway, despite the overload. In this case, it
will be not possible to guarantee the best
washing results.
About 20 minutes after the programme
start, the programme duration could be
adjusted again depending on the
.
capacity of water absorption of the
fabrics.
The ProSense System detection is
carried out with complete washing
programmes only (no skipping phase
selected).
The ProSense System is not available
with some programmes, such as Lana/
Lãs, programmes with short cycles and
without washing phase.
flashes, the ProSense
flashes. the
and the drum
stop flashing. The
ENGLISH
is
25