AEG LFR6194O2V User Manual page 11

Make sure that the plastic guide cannot
move when the appliance drains.
Make sure that the drain hose end is not
immersed in the water. There may be a
return of dirty water into the appliance.
3. To a stand pipe with vent-hole - Insert
the drain hose directly into a drain pipe.
Refer to the illustration.
The end of the drain hose must always
be ventilated , i.e. the inner diameter of
the drain pipe (min. 38 mm - min. 1.5")
must be larger than the external diameter
of the drain hose.
4. If the end of the drain hose looks like this
(see the picture), you can push it directly
into the stand pipe.
5. Without the plastic hose guide, to a
sink spigot - Put the drain hose in the
spigot and tighten it with a clamp. Refer
to the illustration.
Make sure that the drain hose makes a
loop to prevent particles going into the
appliance from the sink.
6. Position the hose directly to a built-in
drain pipe in the room wall and tighten
it with a clamp.
5.6 Electrical connection
At the end of installation you can connect the
mains plug to the mains socket.
The rating plate on the inner edge of the
appliance door and the 'Technical Data'
chapter indicate the necessary electrical
ratings. Make sure that they are compatible
with the mains power supply.
ENGLISH 11