Siemens LC 5KDK6K Series User Manual And Installation Instructions page 29

Close the glass flap.
6.
Slightly raise the glass flap and pull it forwards in
‒
order to loosen the securing position of the
hinges.
Carefully guide the glass flap downwards until it
‒
clicks into place.
Piping
Circulating-air mode
¡ If you are operating the appliance in circulating-air
mode, please observe the information about the cir-
culating air special accessory.
¡ We recommend piping with an exhaust air pipe dia-
meter of 150 mm.
¡ If the diameter of the air extraction ducting is less
than 150 mm, you need a separately available re-
duction fitting.
Note: If you are using an aluminium pipe, smooth the
connection area beforehand.
Establishing the exhaust air connection (exhaust
pipe, 150 mm diameter)
Secure the exhaust pipe to the air pipe connector.
1.
Establish the connection to the exhaust air opening.
2.
Seal the joints.
3.
Connecting to the power supply
1. Insert the mains plug into the protective contact
socket.
If a fixed connection is required, follow the instruc-
2.
tions in the section
→ "Instructions for the electrical connection",
Page 26.
Fitting the flue duct
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
Note: In circulating-air mode, the flue duct section must
be installed before the circulating-air guide is installed.
You can find information about installing the circulating-
air guide in the installation instructions for the access-
ory.
Screw the flue facing onto the angle bracket at the
▶
side.
Removing the appliance
Remove the flue duct.
1.
Disconnect the appliance from the power supply.
2.
Loosen the exhaust pipe.
3.
Remove the filter.
4.
To avoid causing damage, do not bend the grease
filters.
Loosen the screws for the appliance bracket slightly
5.
but do not undo them fully.
Remove the appliance.
6.
Loosen the angle bracket for the flue duct.
7.
Installation instructions en
29