Basic Connection - Roland CompuRhythm CR-8000 Owner's Manual

Basic Connection
qi f
SYNCHRO-INPUT/OUTPUT
8"16" ACC
IN! OUT пи
è ° [M]
(See P. 11)
ANALOG
SEQUENCER
DIGITAL
SEQUENCER 2:
MC-4 DIGITAL
CSQ-600, | SEQUENCER
&OUTPUT
В START/STOP
С RE-START
Connect a Pedal Switch such as
Roland DP-2 to this jack. By depress-
ing the pedal switch, the rhythm being
played can be immediately returned to
the beginning of the bar, which is
available for adjustment of a beat that
gets out of tempo during a performance,
or to create an odd rhythm.
OINTRO/FILL-IN
This jack is used for remote control
options for the Intro or Fill-in function
(without defeating those functions at
the front pane! Manual button).
TRIGGER-OUTPUT
REGISTER /FILLIN RESTART
/STOP
Nu.
¿0
Di
'oa
2.
та.
1
i
|
|
|
|
1
| y
|
|
| le
1
1
| |
1
|
|
| |
1
|
ШЕ
PEDAL SWITCH
DP-2
©REGISTER
This jack provides remote control options
for performing alternately two rhythm
patterns without defeating this function
at the front panel Register button.
(TRIGGER OUTPUT
CR-8000 has Trigger Out for Control
other Sequencer or Synthesizer.
(TRIGGER OUT 8"-16"-ACC SWITCHABLE
CR-8000 provides Trigger Output to allow
interfacing with synthesizer or sequencer.
This Trigger signal is a positive 5V, 10ms
pulse suitable for activating either the
Trigger or Gate inputs of most major
brands of equipments.
'SYNC. IN/OUT
(5 pin DIN connector)
OUTPUT
(SYNC. IN/OUT SELECT SWITCH
The SYNC. IN/OUT section of CR-8000
allows itself to be synchronized perfectly
with units such as the Roland CSQ-600
Digital Sequencer, allowing each unit
total rhythmic freedam with remaining
in perfect tempo, starting and stopping
of both units from the CSQ-600.
CR-8000 can also be synchronized to
the Arpeggio section of Roland JP-8
Polyphonic Synthesizer.
To synchronize two units, connect a
five pin DIN cord to the SYNC. jack on
each unit and move the CR-8000 SYNC.
switch to the INPUT position for con-
nection to the CSQ-600, or to the OUT-
PUT position for connection to the JP-8.
. Remember that the SYNC. switch must
be in the OUTPUT position for the CR-
8000 to operate by itself.