Table of Contents
Advertisement
@ CALL Channel (TM-621A/
721A)
. Press the VFO key to select
the VFO mode.
. Select the desired operating
frequency, offset, tone fre-
quency, etc. (For example
146.520 MHz)
. Press the F key. The F in-
dicator
and
the
memory
channel
indicator
will
light. (For example ch d)
. Press the CALL key within
5 seconds of pressing the
F key. The F indicator and
the
Memory
Channel
number will turn off.
. To
confirm
the
CALL
channel
contents
press
the CALL
key and select
the Channel.
The
NEW
CALL
channel
will appear.
4-5-6.
Memory Recall
Please refer to Frequency Selection page 16.
4-5-7.
Memory Shift
This feature copies memory channel or CALL channel data
to the VFO.
This will allow
you to after these
frequencies
without
changing the actual contents of the memory or CALL chan-
nel.
1. Press the F key. The F in-
dicator
and
the
memory
channel
indicator will ap-
pear.
(For
example
146.100 MHz CH. 8)
2. Press the VFO key within
5 seconds of pressing the
veo
[ae
F key.
Note:
If the indicator goes off,
you must press the F key
again.
The data is copied ot the
VFO mdoe.
|
i
i
(
Advertisement
Table of Contents
