Original Accessories/Auxiliary Equipment; Before Use; Charging The Battery Pack (See Fig. A) - Parkside PAEXS 20-Li A1 Translation Of The Original Instructions

Cordless orbital sander
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 47
Avoid sanding lead paint or other harmful
materials.
Materials containing asbestos must not be
processed. Asbestos is a known carcinogen.
Avoid contact with the sanding sheet while the
appliance is running.
Do not use the appliance without a sanding
sheet fitted.
Never use the appliance for other purposes
and only use original parts/accessories. Using
attachments or accessory tools other than those
recommended in the operating instructions can
lead to a risk of injury.
Always allow the appliance to come to a
complete standstill before putting it down.
The appliance must always be kept clean,
dry and free from oil or grease.
Original accessories/auxiliary
equipment
Use only the accessories and additional
equipment that are specified in the operating
instructions and are compatible with the
appliance.
WARNING!
Do not use any accessories that are not
recommended by PARKSIDE. This can lead to
an electric shock and fire.
PAEXS 20-Li A1

Before use

Charging the battery pack
(see fig . A)
CAUTION!
Always unplug the appliance before you re-
move the battery pack
battery pack to the high-speed charger
NOTE
Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should
be checked regularly. The optimum charge
level is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
Plug the battery pack
charger
(see fig. A).
Insert the power plug into the socket. The red
control LED
lights up.
The green LED
indicates that the charging
process is complete and the battery pack
ready.
ATTENTION!
If the red control LED
that the battery pack
cannot be charged.
If the red and green control LEDs
flash, this means that the battery pack
defective.
Disconnect the power plug from the mains
power socket. Remove the battery pack
the high-speed charger
Never recharge a battery pack
diately after rapid charging. There is a risk that
the battery pack
reduce the lifespan of the again.
Switch the high-speed charger
15 minutes between successive charging pro-
cesses. Also disconnect the power plug from the
mains power socket.
from or connect the
into the high-speed
flashes, this means
has overheated and
both
.
again imme-
will overheat, which will
off for at least
GB │ IE
 21
.
is
is
from

Advertisement

Table of Contents
loading

Table of Contents