Honda BF40 Owner's Manual page 15

Selecting the target engine > Pattern setting
●
adjustment
You can adjust the Pattern value set in "Pattern setting".
• If you select None, adjust the value of each Pattern.
• If you select one of Pattern 1 to Pattern 3, a trim angle
according to each boat velocity or engine speed is set.
Adjust the Pattern value as needed.
• Under the following conditions, Pattern adjust is grayed
out and cannot be configured.
– Trim Zero Set has not been completed. (P.20)
– When the engine does not support the trim support
function
– When an error occurs in the outboard motor
1. Use the [ ∧ ] or [ ∨ ] button to select BOAT SET and press the
[ENTER] button.
2. Use the [ ∧ ] or [ ∨ ] button to select Assist Function and
press the [ENTER] button.
3. Use the [ ∧ ] or [ ∨ ] button to select Trim Support Setting
and press the [ENTER] button.
> Pattern 4. Use the [ ∧ ] or [ ∨ ] button to select Pattern adjust and
press the [ENTER] button.
• The current setting value is displayed according to the
selected Speed Source, Engine, and Pattern.
5. Use the [ ∧ ] or [ ∨ ] button to select the item for which you
want to adjust the value and press the [ENTER] button.
6. Use the [ ∧ ] or [ ∨ ] button to set the engine speed and the
trim angle and press the [ENTER] button.
When you finish setting all the engine speed and trim
angles, use the [ ∧ ] or [ ∨ ] button to select Register and
press the [ENTER] button.
14
To "Configuring the settings" (P.8)