Table of Contents
Advertisement
Chapter 2
Installing the Subscriber Station
Figure 4: Mounting the Subscriber Station to a Small Pole
1. Subscriber Station 2. Pole 3. Clamping Bracket 4. Mounting Bracket 5. M8-25 Hex Screw 6. M8 Spring Washer 7. M8 Flat
Washer 8. M8 Nut 9. M8-70 Hex Screw
2.
Liberally apply an anti-corrosion spray to all galvanized steel components, including mounting brackets, nuts,
washers and screws.
3.
Select a mounting location on the pole.
4.
Position the mounting bracket against the pole.
NOTE
When mounting the subscriber station, note the orientation of the clamping bracket in
Figure
5.
Secure the clamping bracket to the mounting bracket using screws, spring washers and nuts. Make sure the
screws are hand tightened.
6.
Make sure the subscriber station is properly grounded according to local standards. For more information,
refer to
Section 2.7, "Grounding the Subscriber
7.
Tighten the screws connecting the clamping bracket to the mounting bracket. Make sure the screws are
torqued to 14 N·m (10 lbf-ft).
Section 2.6
Installing the Antennas
The RUGGEDCOM WIN5151-V-GPS supports N-Connect female antennas.
To install an antenna, do the following:
12
4
3
5
6
4.
7
Station".
RUGGEDCOM WIN5151-V-GPS
1
8
6
7
6
9
Installing the Antennas
Installation Guide
2
3
Figure 3
or
Advertisement
Table of Contents
