Table of Contents
Advertisement
Camera
Removing the camera
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
wireless
card.
4. Remove the
display
assembly.
5. Remove the
display hinge
6. Remove the
display
bezel.
7. Remove the
display
hinges.
8. Remove the
display
panel.
About this task
NOTE:
This procedure applies only to computers with a plastic chassis.
The following images indicate the location of the camera module and provide a visual representation of the removal procedure.
Steps
1. Disconnect the display cable from the connector on the camera module.
2. Using a plastic scribe, gently pry the camera off the display back-cover and antenna assembly.
3. Remove the camera module from the display assembly.
Installing the camera
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Before working inside your
caps.
computer.
Removing and installing Field Replaceable Units (FRUs)
101
Advertisement
Table of Contents
