Table of Contents
Advertisement
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
This procedure applies only to computers with a plastic chassis.
The following image indicates the location of the display back-cover and antenna assembly and provides a visual representation
of the installation procedure.
Steps
Place the display back-cover and antenna assembly on a flat surface and perform the post-requisites to install the display
back-cover and antenna assembly.
Next steps
1. Install the
display
cable.
2. Install the camera.
3. Install the
display
panel.
4. Install the
display
hinges.
5. Install the
display
bezel.
6. Install the
display hinge
7. Install the
display
assembly.
8. Install the
wireless
card.
9. Install the
base
cover.
10. Follow the procedure in
106
Removing and installing Field Replaceable Units (FRUs)
caps.
After working inside your
computer.
Advertisement
Table of Contents
