4. Lift the bottom side of the display panel and slide it downward to release the display brackets from the slots at the top side
of the display back-cover.
5. Gently flip the display panel assembly forward, peel back the tape that secures the display cable to the connector on the rear
of the display panel.
NOTE:
Ensure that the panel has a clean and smooth surface to rest on, to prevent damage.
6. Disconnect the display cable from the connector on the display panel and remove the display panel.
NOTE:
The display panel is assembled with the display brackets as a single service part. DO NOT pull the two pieces of
elastic tape and separate the brackets from the panel.
Removing and installing Field Replaceable Units (FRUs)
97